Crown-audio DCi Series – Network Input Models Bedienungsanleitung PDF herunterladen (Seite 22)

DriveCore Install Network Series Power Ampliﬁers

Operation Manual

page 22

Set-up and System Conguration

Bridge Mode (16, 8, or 4 Ohm) Output Operation

Typical input and output wiring, along with software settings

are shown in Figure 13.

INPUT WIRING: If using analog inputs, it is only necessary

to wire the odd number inputs. If using the BLU Link input,

it is important to understand that BLU Link is a digital audio

bus and cannot be routed through a network switch or router.

To increase fault protection, use both the input and output

BLU Link wiring connection. For BLU Link routing, refer to

page 25.

OUTPUTS: Connect the speaker across the positive terminals

of each channel pair. Do not use the negative terminals of

the channel pair when the pair is being operated in Bridge-

Mono mode.

Figure 13 System Wiring Bridge Mode

Figure 13 The bridge mono checkbox must be checked for proper operation

Always route the input and output wires in separate bundles.

1 2 ... 17 18 19 20 21 22 23 24 25 26 27 ... 65 66

Keine Kommentare

Crown-audio DCi Series – Network Input Models Bedienungsanleitung Seite 22