Crown-audio DCi Series – Network Input Models Bedienungsanleitung PDF herunterladen (Seite 21)

DriveCore Install Network Series Power Ampliﬁers

page 21

Operation Manual

Set-up and System Conguration

Low-Z (8, 4 or 2 Ohm) Output Operation

Typical input and output wiring, along with Audio Architect

software settings are shown in Figure 12.

INPUTS: Connect the input with wiring in place for each

channel. If the same signal is to drive both outputs of a

channel pair (“mono”), the input signal can be sent to

adjacent ampliﬁer channels. If using the BLU Link input, it

is important to understand that BLU Link is a digital audio

bus and cannot be routed through a network switch or

router. To increase fault protection, use both the input and

output BLU Link wiring connection. For BLU Link routing,

refer to page 25.

OUTPUTS: Maintain proper polarity (+/–) on output

connectors. Connect the Channel 1 speaker’s positive (+)

lead to ampliﬁer Channel 1 positive terminal;

repeat for negative (–). Repeat Channel 2 wiring as for

Channel 1, and for any subsequent channel pairs on

multichannel models. Refer to Page 8

for output connector terminal assignments.

Always route the input and output wires in separate bundles.

Figure 12 System Wiring Dual Mode

Figure 12

1 2 ... 16 17 18 19 20 21 22 23 24 25 26 ... 65 66

Keine Kommentare

Crown-audio DCi Series – Network Input Models Bedienungsanleitung Seite 21